You must be logged in to perform this action

This is an old revision of the document!


Sample Holder

The original sample holder for the diSPIM is an autoclavable stainless steel chamber made by ASI (I-2450). It uses a 24×50 mm coverslip as a transparent bottom. There is only ~5mm travel in both X and Y when 40x/0.8 WD objectives are being used; it was designed to minimize the fluid volume (only a few milliliters). Use the I-3078 stage insert. Contact ASI for CAD files.

A similar but slightly larger ASI-made sample holder accommodates larger objectives including the Nikon 25x/1.1 WD paired with Special Optics illumination objective (I-2460). It uses a 24×60 mm coverslip as a bottom. Contact ASI for CAD files. Use the I-4020 stage insert.

A petri dish is easily used as a sample holder and ASI makes a variety of stage inserts for all manner of dishes. Just make sure you get one large enough to accommodate the objectives, e.g. 85mm diameter.

Rusty Nicovich designed a large 3D printed chamber that fits into the stage in place of an insert and accommodates the cleared tissue objectives. It has a glass bottom and volume ~190mL. CAD files and more details at https://github.com/PRNicovich/3D-Printed-Optics-Lab-Parts/tree/master/ASI%20Large%20Volume%20Chamber.

ASI designed a large 3D printed chamber that fits into the stage in place of an insert and accommodates the cleared tissue objectives. There is space to glue in a Thorlabs SB1 or SB1/M kinematic base so the sample can be mounted to the kinematic top and removed and replaced repeatedly, and ~10mm travel in all dimensions. Depending on the 3D printed material it may be useful to seal it with epoxy or some other leak-proof coating. CAD files are available here.

A key advantage of the oSPIM system is that it can use 35mm glass-bottom dishes.